Introduction #
This device works with unencrypted cards, it will not work with encrypted cards. It may work with semi-encrypted cards, but this is not guaranteed and will be on a case-by-case basis.
Please note, that when copying to a new card, the card has to be a writable device, not all are writeable.
Working Frequencies #
ID Cards:
- 125 kHz
- 250 kHz
- 500 kHz
- 375 kHz
- 625 kHz
- 750 kHz
- 875 kHz
- 1000 kHz
IC Cards:
- 13.56 MHz
- 125 kHz
Instructions #
Steps for copying 125kHz and 13.56MHz RFID cards:
- Turn the device on by pressing the On/Off button
- You will be presented with a disclaimer screen which you will need to agree with to continue
- Place the original card on the back of the device and press the Scan button.
- The device will then read the original card and the card number will be displayed on the screen.
- Remove the original card from the back of the device and place a re-writable card on the back of the device.
- Press the Write button, this will now write the original card ID to the new card.
Steps for cracking encrypted 13.56MHz cards:
Please note, these steps should be used only at your own discretion as the software is supplied by the manufacturer and we offer no guarantees on its operation, and should only be used for legitimate purposes.
These steps need to be done on a Windows computer and used when needing to crack 13.56MHz card encryption, there is no guarantee this will work on all encrypted devices.
- Connect the device to a windows computer via a USB cable
- Turn the device on by pressing the On/Off button
- The device will now turn on and display the disclaimer page. DO NOT PRESS ANY BUTTONS ON THE DEVICE
- The computer will then detect the device as a removable drive, similar to when connecting a USB flash drive
- Browse to this device, and open it up. Inside there will be an instruction document and software.
- Refer to the instruction document on how to use the included software
